17
Use a 1/4 bit to drill the engine mount-
ing holes
Remove mounting template from re-
wall. Firewall shown with mounting holes
drilled ready for engine mounting.
Using mounting bolts and washers
mount engine to rewall.
Tighten mounting bolts and secure en-
gine to rewall.
1) Use a 1/4” bit to drill a pushrod exit
hole in the rewall in line with the en-
gine carburetor throttle arm.
2) Assemble ball link to threaded end of
pushrod.
THROTTLE SERVO INSTALLATION.
To Next Page
Loading...
