4
INSTALL THE AILERONS
CONTROL HORN.
Epoxy.
Epoxy.
Aileron control horn.
INSTALLING THE AILERON SERVOS.
1) e ailerons have been pre-hinged
and glued to the wing panels and are
ready for ight. No other steps are neces-
sary for hinging.
2) Layout the servo on the wing to test t
the installation and ensure servo lead is
the correct length.
3) Attach the extension to the servo lead
and secure with Safety Clip, safety wire,
tape or other method. Ensure the plugs
will not come apart from vibration or
light tension.
4) Fasten the pull string from the servo
hole to the male plug of the servo exten-
sion.
Fiberglass control horn
To Next Page
Loading...
