3
� 35-40cc gasoline engine.
� Computer radio 7 channel with 8
servos.
� Glow plug to suit engine.
� Propeller to suit engine 20x8-21x10.
� Protective foam rubber for radio
system.
KIT CONTENTS
SEA388 RV-8 ARF 35-40cc
1. Fuselage
2. Wing set (2)
3. Tail set (2)
4. Canopy
5. Cowling
6. Wing tube
7. landing gear
8. Fuel tank
9. Tail wheel
10. Pushrod
11. Ep Motor box
12. Pilot
13. Spinner
14. Wing tips bulbs
ADDITIONAL ITEMS REQUIRED
TOOLS & SUPPLIES NEEDED
in cyanoacrylate glue.
Medium cyanoacrylate glue.
30 minute epoxy.
5 minute epoxy.
Hand or electric drill.
Assorted drill bits.
Modelling knife.
Straight edge ruler.
2mm ball driver.
Phillips head screwdriver.
220 grit sandpaper.
90° square or builder’s triangle.
Wire cutters.
Masking tape & T-pins.
read-lock.
Paper towels.
HINGING THE FLAP
Note : e control surfaces, including the ailer-
ons, elevators, and rudder, are prehinged with
hinges installed, but the hinges are not glued in
place. It is imperative that you properly adhere
the hinges in place per the steps that follow us-
ing a high-quality thin C/A glue.
Carefully remove the aileron from one of
the wing panels. Note the position of the
hinges.
1.
C/A Hinge
Slide the wing panel on the ap until
there is only a slight gap. e hinge is now
centered on the wing panel and ap. Re-
move the Tpins and snug the ap against
the wing panel. A gap of 1/64” or less
should be maintained between the wing
panel and ap.
2.
Remove each hinge from the wing panel
and ap and place a T-pin in the center of
each hinge. Slide each hinge into the aileron
until the T-pin is snug against the aileron.
is will help ensure an equal amount of
hinge is on either side of the hinge line when
the ap is mounted to the wing panel.
Hinge
T-pin
To Next Page
Loading...
