RV-8 ARF 35-40cc
Instruction Manual.
36
2.
INSTALL ATION PILOT AND CANOPY
Locate items necessary to install pilot
and canopy.
1.
If you are going to install a pilot gure,
please use a sanding bar to sand the base
of the gure so that it is at.
Position the pilot gure on the canopy
oor as show. Locate the oval shaped on
the canopy oor and remove the cover-
ing. Use epoxy to glue this into the base of
the pilot gure and glue the cockpit panel
in place with C/A glue, please see pictures
as shown.
A scale pilot is included with this ARF.
e Pilot included tting well to the cock-
pit. (or you can order others scale pilot
gures made by SG Models. ey are
available at SG Models distributors.)
2.
Epoxy canopy onto the fuselage. Trace
around the canopy and onto the fuselage
using a epoxy.
3.
Epoxy
INSTALLING THE BATTERY-RECEVER
Plug the servos leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
4.
Epoxy
150mm
To Next Page
Loading...
