Sebart Wind S 110 ARF - Section 5 B - Servo & Control Horn Installation (F3 A + 3 D Option)

 step 6
Install the elevator on the fuselage, with the two screws and washer included in the hardware pack.
 step 7
Repeat steps 1 through 6 for the remaining stabilizer.
Section 5B – servo & control horn installation (F3A + 3D option)
 step 1 (LEFT side)
Locate the following items, included in the hardware pack and the standard size servo (not
included). Install the servo hardware (gommets and eyelets) included with the servo.
15