Sebart Wind S 110 ARF - Section 9 - Electric Motor Installation

 step 8
Once satisfied with the fit, glue the fillet on the landing gear using medium CA.
Use the glue carefully avoid over runs on other areas.
 step 9
Repeat steps 2 through 8 for the opposite landing gear side.
Section 9 – electric motor installation
We recommend to fly HACKER motor, you need the following item (not included):
• Hacker A50-16L + MasterBasic90-Opto controller + APC 18x10E or 18x12E
 step 1
Locate the following items.
30