Required radio, motor and battery
Radio equipment:
• 6-channel radio system
• 5 digital servos, with two options: > F3A + 3D……5 JR DS 8401 or DS 8411
> ONLY F3A….3 JR DS 8401 + 2 JR DS 3201
• 2 servo extension 100mm, for aileron’s servos
• 2 extension 400mm, for elevator’s servos
Recommended electric motor for best performance:
• Hacker A50-16L + MasterBasic 90-Opto + APC 18 x 12E
Recommended Li-Po battery pack for best performance:
• FlightPower 4270mAh 8S Evolight .….for ONLY precision F3A
• FlightPower 4350mAh 8S 30C…..for unlimited 3D and precision F3A
Additional required item, tools and adhesives
Tools:
• Drill
• Drill bits: 1,5mm; 2mm; 2,5mm; 3mm
• Phillips screwdriver
• Hobby knife
• Masking tape
• Paper towels
• Rubbing alcohol
• Sand paper
• Soldering iron
• synthetic oil
Adhesives:
• 5-minute epoxy
• thin CA
• medium CA
Warning
This RC aircraft is not a toy!
If misused, it can cause serious bodily harm and damage to property.
Fly only in open areas, preferably in official flying sites, following all instructions included with
your radio and motor.
This plane is a compromise between Aerobatics and 3D flying, and not a pylon racer.
It is built with a very light structure and for this reason we hardly recommend:
→ Do NOT fly your airplane at high speeds
, because this may cause structural
failures or flutter due to the extremely large control surfaces.
3
To Next Page
Loading...
