100 •
NOTE
The wireless module is switched off when
factory settings are restored. Information about
existing wireless groups is retained. Wireless
groups do not have to be set up again.
1. Select the item "rESEt" from the menu.
2. Confirm the selection.
You will leave the menu automatically.
3. Switch the scales off.
Factory settings are restored and are available
when the scales are next switched on.
6. OPERATE HEAD SLIDE
6.1 Measure height
Start measuring height 1. Press the Start key of the head slide.
“----” appears in the display.
NOTE
•If you want to transmit the measured result to
receivers from the
seca 360° wireless
system, ensure that the receivers are
switched on.
•If you want to use the measured result to
calculate the BMI or BFR, ensure that the
multifunctional display is also switched on.
2. Keep the brake button pressed and move the head
slide until a length (height) value appears in the
display.
3. Hold down the brake button and push the head
slide up far enough so the patient can get under it
comfortably.
Wireless module (SYS) off
Autosend (ASend) off
Autoprint (APrt) off
Function Factory setting
To Next Page
Loading...
