7 PRECAUTIONS WHEN MOVING THE MACHINE
• When moving the cabinet, do not grip or push the Controllers. Doing so could
deform or damage the part.
• If moving through a door or place with a low ceiling such as an elevator, you
should take apart the billboard and billboard plate.
• Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing re or
electric shock.
• To move the unit over the floor, pull in the adjustors and have the casters
contact the oor. While moving the unit, be careful that the casters do not roll over
the power cord or the ground wire. If cord or wire is damaged, there could be
electrical shocks and/or short circuits.
• When crossing a sloped or stepped area, always have the machine travel
lengthways. Travelling with the machine in a sideways position could result in the
machine falling over onto its side. Always use a minimum of two people working
together plus lifting apparatus to accommodate slopped areas or stairs.
• To lift up the cabinet, hold it at the bottom at the designated lifting points. If you
hold it anywhere else, the weight of the cabinet could cause damage to parts or
attachments, resulting in injury.
• Do not push the cabinet from the side when moving. Pushing from the side as it
may result in the cabinet falling over.
DetailedinstructionsforremovingtheAssyBillboardandBillboardPlatecanbefoundinChapter6ofthismanual.
Pleasefollowtheseinstructioninreverseorderforremoval.
To Next Page
Loading...
Need help?
General
