Following pictures are for reference only. Your model may be
slightly different. It is best to let Segway Powersports dealer to
adjust if conditions permit.
HIGH BEAM ADJUSTMENT
The headlight beam can be adjusted slightly up/down. Use the
following procedure to make adjustments.
1.
Place the vehicle on a horizontal floor with a headlight
position of about 10 m from the wall.
2
2.
Measure the distance from the floor to the center of the
headlights and mark the line on the wall at the same height.
3.
Start the engine. Switch headlights to high beam.
4.
Watch the headlights aim at the wall. The strongest part of the
headlight beam should be 5 cm below the mark on the wall.
Measurement must include weight of the driver on the seat.
To Next Page
Loading...
