Segway AT5 S - Battery Installation

132
To reduce the chance of sparks: Whenever removing the battery,
disconnect the black (negative) cable first. When reinstalling the
battery, install the black (negative) cable last.
NOTICE
BATTERY INSTALLATION
1. Clean battery terminals with a soft wire brush and contact
cleaner, such as Maxima Electrical Contact / Brake Cleaner.
Finally coat the terminals and bolts with dielectric grease.
2. Insert the battery into the tray.
3. Connect and tighten the red (positive) cable.
4. Connect and tighten the black (negative) cable.
5. Install a clear battery vent from the vehicle to the battery
vent. (For conventional batteries only).
6. Install the battery holder.
7. Tighten the battery clamp bolt.
8. Verify that cables are properly wired.
MAINTENANCE, STORAGE AND TRANSPORTATION