When releasing or retrieving the winch rope, both ends of the rope
must be left with sufficient length to prevent the rope from being over-
rolled in or out. When the rope is retrieving, please maintain a certain
tension so that the wire can be retracted smoothly and can be wound
tightly during retrieving.
Always use the tow rope to pull the hook. Do not hold the hook with
your hands. This is not only important when winding the wire rope, but
also when removing the wire rope from the winch under power.
•
The winch rope and the vehicle should be in a straight line.
Too big an angle will change, the direction of the pulling force,
thereby damaging the rope.
•
If severe noise or vibrations occur during the use of the
winch, it must be stopped immediately.
•
When the winch is not used, please remove the controller.
To Next Page
Loading...
