Troubleshooting Possible causes Solutions Reference pages
Hand Movement
The seconds hand moves at 2-second
intervals. The energy depletion forewarning function is activated. (P. 39)
If the seconds hand moves at 2 or 5-second intervals while you wear the watch
every day, the watch is in a condition where it cannot acquire sufficient light,
for instance, the watch is concealed under a long sleeve shirt.
Charge the watch sufficiently until the seconds hand moves at 1-
second intervals and the multi-indicator hand returns to the day of the
week display from a charging status display of “low.”
Be careful not to conceal the watch under a sleeve, etc., while wearing
it.
When taking off the watch, place it in as bright a location as possible.
middle
P. 14
P. 16
The seconds hand moves at 5-second
intervals.
The stopped seconds hand pointing to
the 15-second position started
operating.
The power save function 1 has been activated. (P. 39)
When the watch has not been exposed to sufficient light continuously, the
power save function 1 to limit energy consumption is automatically activated.
When the watch is exposed to light, the hand will rapidly advance and return to the current time.
When the watch returns to the current time, use it as is. (This is not an abnormal movement.)
-
The stopped seconds hand pointing to
the 45-second position started
operating.
The power save function 2 has been activated. (P. 39)
When the watch is not sufficiently charged for a certain period of time, the
power save function 2 is automatically activated.
① Charge the watch sufficiently until the multi-indicator hand returns to the day of the week display
from a charging status display of “low.”
② After that, when the time is incorrect, adjust the time zone as necessary.
P. 14
P. 16
P. 21 - 22
The watch hands advance rapidly
unless a button is pressed. After the
rapid advancement is completed, the
watch resumes its normal 1-second
interval movement.
The power save function has been activated. (P. 39)
The automatic hand position alignment function was activated.
When the hand positions deviate to display incorrect time as a result of external
influences, etc., the watch automatically corrects the hand misalignment by
the automatic hand position alignment function.
No operation is needed (this is not an abnormal movement.) -
The indicator hand indicates the “LS”
The automatic leap second reception function is operating.
(P. 33)
It takes up to 18 minutes to receive the leap second data.
Pay attention to the reception place “(Place where GPS signals can be easily received).” P. 18
P. 33
Troubleshooting
56
7
TROUBLESHOOTING
5X83 GPS SOLAR
To Next Page
Loading...
