Seiko S141 - Block Memory Recall Procedures; Recall (Stopped;Reset) in Block Mode

11
English
When the stopwatch is reset while the block memory mode is selected, a new “block number” is assigned to the next sequence of data.
A block of data with a block number is automatically accompanied by the starting time and date of measurement, which is convenient for easy
data management.
*A block of data contains at least three data components; block number, measured lap/split time(s), starting time and date. If more than one block of data is stored in memory, the
memory may reach a capacity limit even before the total number of lap/split time measurement totals to 300.
Block number
* The data can be recalled successively by keeping “C” pressed.
* To stop the recall of the data when the stopwatch is stopped, press “A”, “B” or “D.” To stop the recall of the data when the stopwatch is reset, press “A” or “D.”
● With each press of “C,” the data is recalled chronologically (starting from the first/oldest data in block “1”).
Ex.: When the stopwatch is reset to “00” in block 4
C
▼
▼
▼
▼
Data of
block 2
▼
Data of
block 3
Reset Start time & date
(block 1)
Fastest lap time
(block 1)
Split & lap times
(block 1)
Stop time
(block 1)
▼
1. MEMORY RECALL WHEN THE STOPWATCH IS STOPPED OR RESET
▼
○○○
Block number
Date
Fastest lap time
Fastest lap number Lap/Split number Split time
Starting time