15
English
● With each press of “C”, the data is recalled starting from Memory-1.
* The data cannot be recalled while the measurement is being made.
2. RECALL OF THE STORED DATA
3. HOW TO CLEAR THE STORED DATA
● Once the following steps are taken, all the stored data are erased from memory.
The stored data cannot be erased one by one.
1. Press “C” to show the MEMORY RECALL display.
2. Keep “B” pressed for more than 1.5 seconds.
* While the button is kept pressed, the display shown at right appears with warning beeps.
* After 1.5 seconds, all the stored data is erased from memory with a long beep. Then, the initial
measurement display is shown.
* Unless “B” is kept pressed for more than 1.5 seconds, the stored data will not be erased from
memory.
B
C
BATTERY CHANGE
The lithium battery which powers your watch should last approximately 3 years. However, because the battery is inserted at the factory to check the function
and performance of the watch, its actual life once in your possession may be less than the specified period. When the battery expires, be sure to replace
it as soon as possible to prevent any malfunction. For battery replacement, we recommend that you contact an AUTHORIZED SEIKO DEALER and request
SEIKO SB-T74 battery.
* If the stopwatch is used for more than 3 hours a day, the battery life may be less than the specified period.
● Battery life indicator
* When the battery is replaced with a new one, all the stored data will be erased from memory.
When the battery nears its end, a flashing battery mark “BATT” is displayed. In that case, have the battery replaced with a new one as soon as possible
by the retailer from whom the stopwatch was purchased or an AUTHORIZED SEIKO DEALER.
To Next Page
Loading...
