Seko OPL BASIC - GETTING STARTED; 1.1 WELCOME; 1.2 WHATS IN THE BOX?; 1.3 TECHNICAL FEATURES

OPL BASIC cod. 0000136322
rev. 2.2
2
1
GETTING STARTED
1.1
WELCOME
Get ready for a whole new experience.
OPL Basic
has a fresh, new look and it’s easier than ever to use.
This proven chemical dispensing system is engineer
ed to dispense one or two chemicals. Chemical feeds
either by a trigger signal directly from the washer or manually by the operator with the activating switches on
the front cover. It is also possible to activate the unit dispensing with a remote switch (o
ptional) to be
connected to the
OPL Basic
.
A unique “Product Lockout” feature helps you control costs and product consumption.
This book explains how to install and set up the
OPL Basic
and where to turn for help so you can enjoy the
most intuitive dosing
system yet.

Please review this manual carefully. Pay particular attention to warnings and precautions.
Always follow good safety procedures, including the use of proper clothing, eye and face
protection.

Please read through entire manual and choose
operating mode before you begin installation.
1.2
WHAT’S IN THE BOX?
Before you start, check that your box contains the following items:


OPL Basic
system;


Instruction manual;


Mounting kit;


PVC tube: 8x12 (4 m) each pump.
1.3
TECHNICAL FEATURES


Power su
pply: 115/208/230 Vac 50/60 Hz


Consumption: 14 W


Fuse: 315mA @ 250VAC, 5x20 type


Protection of the System: The gasketed enclosure on the
OPL Basic
is highly water resistant and the
electronics are further protected within the enclosure
.
1.4
WARNINGS

Check the voltage of the main power source and make sure that it matches one of the three available
input voltages (115/208/230
vac
) of the transformer inside the OPL BASIC.

All electrical connections to the OPL BASIC should first be verified with a m
eter. Application of incorrect
voltage will permanently damage the
unit and is not covered under warranty. Avoid wiring to any power
source that has large fluctuations in voltage and/or is prone to surges. Refer to the wiring diagram in this
manual for a
ll power and signal connections.

For all connections, please refer to the circuit board schematic contained in this manual

Check the model of the equipment you have purchased for the references about installation, setting and
programming.

CAU
TION: The OPL BASIC
has high voltage connected to the transformer. Always disconnect power
when servicing the unit.

CAUTION: During installation and electrical connections remove all
power from the dishwasher.

Failure to follow these instruction
s may lead to personal injury, damage to the product or poor product
performance.