5. Measurement
NOTE: ● There is a danger of electric shock if the meter is handled with
wet hands, during rain, in areas splashed by water or where
there is a lot of moisture, if you use cord flash mode.
● The electronic flash unit may trigger when you connect the
synchro cord or operate the Power button.
● For flash unit with an extremely low trigger voltage, the flash
may not fire. In this case, make measurements in auto reset
cordless flash mode. (See page 16)
● When triggering a flash bulb to take measurement, please
check the cameras synchronizing range and set the proper
shutter speed.
REFERENCE: • It is possible to switch the shutter speed between full, 1/2 or
1/3 stops by custom setting (see page 19).
• Shutter speed can be set from 1sec, 0.8sec through to 0.3 sec,
1/4 through to 1/500 sec and followed by 1/75, 1/80, 1/90 and
1/100.
• After measuring, if the shutter speed is changed, the
measurement value (aperture value) will revert to zero. In such
cases please measure again.
• If ISO film speed is altered after measuring, a calculated value
(aperture value) will be displayed.
• Even if settings are within the measurement range of the
L-308S, the E.o or E.u symbol may appear for the aperture
value corresponding to the set shutter speed.
Change the shutter speed or measure again using the following
methods.
✩ When the display range is exceeded (E.o), press the Up button y to change
the shutter speed to the high-speed side within the synchronizing range of
the camera, or lessen the quantity of flash light and measure again to display
a measurement value (aperture value).
To Next Page
Loading...
Need help?
General
