5. Measurement
2. Measuring Flash Light
This measuring method comprises the cord and cordless flash modes. Measure
the flash light to display shutter speed and aperture value (total amount of light
combining ambient light and flash light) on the LCD.
2-1 Cord Flash mode
This measuring methad is used to make sure
synchronization with flash units, or to measure
flash bulb by connecting Synchro cord.
1) Connect the flash synchro cord to the flash
synchro terminal o on the exposure meter.
2) Press Mode button e to select cord
flash mode.
3) Press the Up button y or the Down
button u to set the shutter speed. When
setting shutter speed, first check the
settings to confirm that they correspond to
the settings on the camera.
4) Press the measuring button r to trigger
the flash. The measurement value (f stop
value) will be displayed.
ā Please place in a location where an infant cannot reach and
accidentally swallow the synchro terminal cap. There is danger
of strangulation.
To Next Page
Loading...
Need help?
General
