4. Basic Operation
1. Incident or reflected light measuring
1) To set for either incident or reflected light operation, slide the Lumisphere w
mounting until it clicks.
Incident light mode Reflected light mode Setting operation
NOTE: ● Always use the Lumisphere mounting for setting.
Hand operation of the Lumisphere may cause damage.
● The Lumisphere is an important light receiving unit. Please
handle with care and try not to mark or soil.
Wipe Lumisphere with a dry soft cloth if it becomes dirty.
Never use organic cleaners (like thinner or benzene) to clean
Lumisphere.
2. Setting measuring mode
1) Press the Mode button e to select a mode.
The mode switching sequence is as follows.
To Next Page
Loading...
