Selco Genesis 35 - Safety Symbols and Indicators; Imminent danger of serious body harm

To Next Page

To Previous Page

INDEX

SYMBOLS

Imminent danger of serious body harm and dangerous behaviours that may lead to serious body harm

Important advice to be followed in order to avoid minor injuries or damage to property

Technical notes to facilitate operations

1 WARNING ...................................................................................................................................................17

1.1 Work environment ...............................................................................................................................17

1.2 User's and other persons' protection.....................................................................................................17

1.3 Protection against fumes and gases ......................................................................................................18

1.4 Fire/explosion prevention .....................................................................................................................18

1.5 Prevention when using gas cylinders ....................................................................................................18

1.6 Protection from electrical shock ...........................................................................................................18

1.7 Electromagnetic fields & interferences ..................................................................................................18

1.8 IP Protection rating ..............................................................................................................................19

2 INSTALLATION.............................................................................................................................................19

2.1 Lifting, transport & unloading ..............................................................................................................20

2.2 Positioning of the equipment ...............................................................................................................20

2.3 Connection ..........................................................................................................................................20

2.4 Installation ..........................................................................................................................................20

3 SYSTEM PRESENTATION ..............................................................................................................................21

3.1 General................................................................................................................................................21

3.2 Front control panel ..............................................................................................................................21

3.3 Rear panel ..........................................................................................................................................22

3.4 Sockets panel ......................................................................................................................................22

4 ACCESSORIES ..............................................................................................................................................22

4.1 S45 torch .............................................................................................................................................22

5 MAINTENANCE ............................................................................................................................................22

5.1 Removing the torch .............................................................................................................................23

6 TROUBLESHOOTING ..................................................................................................................................23

7 PLASMA CUTTING THEORY ........................................................................................................................24

7.1 Plasma cutting process .........................................................................................................................25

8 TECHNICAL SPECIFICATIONS .....................................................................................................................25