MANUAL DE INSTRUCCIONES CODIGO 80342 REV O 11/2021 Pag.: 33
J.P. SELECTA s.a.u. Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
1. General Information
• Handle the package with care. Unpack it and check that the content matches what is indicated in the “Pac-
king list” section. If any damaged component or the absence of any is observed, notify the distributor quickly.
• Do not install or use the equipment without rst reading this instruction manual. These instructions are an
inseparable part of the equipment and must be available to all its users.
• Consult any doubt to the technical service of J.P. SELECTA, s.a.u.
• Do not use the equipment in explosive, ammable or corrosive atmospheres.
2. Packing List
Item 150 L 80L 20L
4002423 4002424 4002429
Hoses 3/4’ (Steam / Water / Drain) x3 46143
1x Press lids for jar lids 34370
1x Drill jar lids 12039
3.TechnicalSpecications
4002423 4002424 4002429
Item
150L
80L 20L
Network voltage: III 400V I 230V I 230V
Electric power: (W) 7500 4000 2800
Maximum intensity per phase: (A) 12 18 12
Fuses: (fast, type H, dimensions: 10x38mm) 32A 20A 20A
Network connection cable: R, S, T, Neutral, Earth (section 2.5mm
2
) L/N/PE (section 4mm
2
) L/N/PE (section 1.5mm
2
)
Weight (Net Kg): 250 125 50
Useful dimensions (cm Ø x depth) Ø50x70 Ø40x60 Ø25x40
Ext measurement: (cm Depth x Width x Height) 95x120x80 72x58x117 70x38x38
Nominal Volume: (Liters) 150 80 20
Maximum load: (Kg) (Metal) 50 20 10
Weight per support (Kg / cm2) Empty 2.5 2.5 2.5
Weight per support (Kg / cm2) Load + Water 2.5 2.5 2.5
Total space occupied + doors + (optional crane) Add 1.2 m to height Add 40cm to height *Does not adapt
Minimum external water pressure (relative bar) 2
Volume of water per cycle (Liters) 25 20 15
Water quality * Soft water (see classication table)
Thermal energy transmitted to the environment: (W / h) 525 600 375
External water inlet connection 3/4’’
Acoustic Level: Below 70 dBA
Operating regime: Continuous with intervals of 20 minutes between each cycle.
Environmental conditions: Indoor use. Altitude up to 2000m
Ambient temperature between Ambient temperature 5ºC and 40ºC.
Maximum relative humidity 80% up to 31ºC, linearly up to 50% relative humidity at 40ºC
Overvoltage level: Category II
Degree of contamination: 2
Material in contact with steam: Stainless steel, Copper, Teon, Brass
Chamber material: Stainless Steel
Pipes material: Copper, Brass