Selve i-R Timer Plus - 3 Reprogramming if a Transmitter Is Faulty or Lost

GB
79
Transmitter programming procedure
3.) Reprogramming if a transmitter is faulty or lost
If a learnt transmitter is no longer available (due to loss or a fault),
proceed as follows:
Disconnect from the power supply
The receiver acknowledges this reprogramming mode by means
of a brief upwards and downwards movement of the drive.
Within approx. 4 minutes, press the PROG button for
the new transmitter for 3 seconds (wait until the trans-
mitter control light flashes once).
The new transmitter is now learnt into the receiver.
Note: The reprogramming mode is ended either using a control
command from a transmitter that has been learnt or as a result
of successful programming. If reprogramming mode has been
carried out successfully, all previous transmitters will have been
unlearnt are deleted. Only the newly programmed transmitter is
active (safety function).
Important: Please ensure that all receivers connected to the
subdistribution are put into reprogramming mode at the same
time by disconnecting the supply as above. If you then activate
the PROG button for 3 seconds, the new transmitter will
be learnt into all receivers in reprogramming mode (See 4. for
remedy).
PROG.
3 sec.
disconnect
from the
supply for
3 seconds
connect
to the
supply for
3 seconds
disconnect
from the
supply for
3 seconds
connect
to the supply