Selve i-R Timer Plus

To Next Page

To Previous Page

First press the STOP button

and then the UP and DOWN

buttons as well. Keep all

three buttons depressed for

9 seconds, in order to start the

group separation (wait until the

transmitter control light flashes three times).

Important: This transmitter is deleted after the group separation

is completed.

The receiver acknowledges activation of the group separation by

a short movementof the drives of 3 seconds.

Within the 3-second time slot,

stop the movement of the drive

using the STOP button on the

transmitter to be learnt. The

transmitter will be learnt and the

receiver will no longer be in

group separation mode.

If the receivers still run in a group, repeat the process for the

relevant drives.

Note: Group separation is ended either using a control com-

mand from a transmitter that has been learnt or as a result of

successful programming of the new transmitter.

To programme a transmitter which has not been programmed

using the STOP button follow the instructions in section 1.1.

Transmitter programming procedure

9 sec.

1. 2.

3 sec.

Selve i-R Timer Plus - Page 81