Sena M1 - Pairing When the M1 is Turned Off; Pairing When the M1 is Turned On

M1 Smart Mountain Bike Helmet | 14
3 PAIRING THE BLUETOOTH SYSTEM WITH OTHER BLUETOOTH DEVICES
3. If your mobile phone asks for a PIN, enter 0000.
=
PIN
NUMBER
Note:
• The phone pairing mode lasts for 3 minutes.
• To cancel phone pairing, tap the Center Button.
3.1.2 Pairing When the M1 is Turned Off
1. Press and hold the (+) Button and Center Button for 5 seconds
when the M1 is turned off.
Phone Pairing
=
5s
HOLD
“Phone Pairing”
=
Alternating blue and red flashing lights indicate the device
is now discoverable.
2. With your mobile phone in Bluetooth-pairing mode, select M1 in the
list of devices detected.
3. If your mobile phone asks for a PIN, enter 0000.
=
PIN
NUMBER
3.1.3 Pairing When the M1 is Turned On
1. Press and hold the Center Button for 10 seconds when the M1 is
turned on.
Phone Pairing
=
10s
HOLD