M1 Smart Mountain Bike Helmet | 28
10 CONFIGURATION SETTING
10.2 Software Configuration Setting
You can change the settings of the Bluetooth system through the Sena
Device Manager or the Sena Utility App.
10.2.1 Unit Language
You can select the device language. The selected language is
maintained even when the Bluetooth system is rebooted.
10.2.2 Voice Prompt (Default: Enable)
You can disable voice prompts by software configuration settings, but
the following voice prompts are always on.
- Bluetooth system configuration settings menu, battery level indicator,
FM radio functions
10.2.3 RDS AF Setting (Default: Disable)
Radio Data System (RDS) Alternative Frequency (AF) Setting allows
a receiver to re-tune to the second frequency location when the first
signal becomes too weak. With RDS AF enabled on the receiver, a radio
station with more than one frequency can be used.
10.2.4 FM Station Guide (Default: Enable)
When FM Station Guide is enabled, FM station frequencies are given
by voice prompts as you select preset stations. When FM Station Guide
is disabled, the voice prompts on FM station frequencies will not be
given as you select preset stations.
10.2.5 Sidetone (Default: Disable)
Sidetone is audible feedback of your own voice. It helps you to naturally
speak at the correct level according to varying helmet noise conditions.
If this feature is enabled, you can hear what you are speaking during an
intercom conversation or a phone call.
10.2.6 Advanced Noise Control™ (Always on)
The background noise is reduced during an intercom conversation.
To Next Page
Loading...
