PRISM
12
2.2 Charging
You can charge the camera by connecting the supplied USB power & data cable to the charging
port. If the back door of the camera is closed, uncover the charging port and use it. If the back door
is open, you can see that the charging LED beside the charging port turns red while charging and
blue when fully charged.
Note:
1. You can use all the functions of the camera while charging the battery.
2. It is recommended to fully charge the camera before the initial use.
3. When you receive a low battery warning from the camera, charge it using the micro-USB cable.
2.3 Powering On and Off
To power on the camera, press and hold the Mode Button
M
and the Shot Button
S
at the same
time for about one second. To power off the camera, just press the Mode Button
M
and the Shot
Button
S
at the same time.
2.4 Voice Prompt
If the camera is paired with a Bluetooth headset, the voice prompts will help you audibly understand
which mode you are in and the operation you have performed. For more details on how to pair the
camera with a Bluetooth headset, please refer to the section 9.4, “Device Settings”.
To Next Page
Loading...
