Do not drive fasteners close to
the edge of the work surface. The
workpiece is likely to split and the
fastener could y or ricochet and hit
someone.
Never use any part of the tool
(i.e., the cap or mainbody ) as a
hammer. The tool may activate or
become damaged and result in an
unsafe condition.
Keep hands and other body parts
away from the area shown in the
circle to avoid possible injury during
operation.
(1) Read and understand tool labels and manual. Failure to follow warnings could result in
DEATH or SERIOUS INJURY. (2) Operators and others in work area MUST wear safety
glasses with side shields. (3) Keep fingers AWAY from trigger when not driving fasteners
to avoid accidental firing. (4) Choice of triggering mechanisms is important. Check manual for
triggering instructions. (5) NEVER point tool at yourself or others in work area. Always point tool
away when connecting battery. (6) Do not alter or remove trigger or safety.
Do not use tool without Danger
Label on tool. If label is missing,
damaged or unreadable, contact
your SENCO representative to
obtain a new label at no cost.
manual
» Lea el manual
de la herra-
mienta
Read and understand tool labels
and manual. Failure to follow
warnings could result in DEATH or
SERIOUS INJURY.
Operators and others in work area
MUST wear safety glasses with
side shields.
Keep ngers AWAY from trigger
when not driving fasteners, to avoid
accidental ring.
Choice of triggering method is
important. -
Never point tool at yourself or oth-
ers in work area.
» Use protección
ocular
-
» Lesiones perso-
nales
» Blessures
Holding the work by hand or
against your body is unstable and
may lead to loss of control.
10
To Next Page
Loading...
