9
Disconnect tool from battery when:
Outside of the operator's
supervision or control.
Performing maintenance or
repair
Clearing a jam
Moving the tool to a new
location
With battery disconnected, make
daily inspection to assure free
movement of workpiece contact
element and trigger. Do not use
tool if workpiece contact element or
trigger sticks or binds.
Always remove nger from trigger
when not driving fasteners. Never
carry the tool with nger on or un-
der trigger. Tool will eject a fastener
if the workpiece contact element is
bumped and the trigger is pulled.
Drive fasteners into work surface
only; never into materials too hard
to penetrate.
Do not drive fasteners on top of
other fasteners or with the tool at
too steep of an angle; the fasteners
can ricochet and hurt someone.
When using tool, care should be
taken due to possibility of tool
recoil after a fastener is driven. If
workpiece contact element is un-
intentionally allowed to re-contact
work surface following a recoil, an
unwanted fastener may be driven.
Therefore, allow tool to recoil
completely off work surface after
a fastener is driven to avoid this
condition. Do not push workpiece
contact element on work surface
until a second fastener is desired.
To Next Page
Loading...
