8
-
It is not
designed for electric cable installa-
tion and may damage the insulation
of electric cables thereby causing
electric shock or re hazards.
A battery short can cause a large
current ow, overheating, possible
burns and even a breakdown.
Do not touch the terminals with
any conductive material.
Avoid storing battery cartridge
in a container with other metal
objects such as nails, coins, etc.
Do not expose battery cartridge
to water or rain.
Consecutive charging may cause
overheating. If you need to re-
charge batteries consecutively, wait
about 15 minutes for the charger
to cool.
Fusion
To prevent eye injuries, always
wear OSHA required "Z87" safety
glasses with permanently attached
rigid, hard plastic side shields.
These safety glasses must have
"Z87" printed or stamped on them.
Be sure everyone in your work area
is wearing the same type of safety
glasses.
The Fusion tool is charged with
compressed air in a factory sealed
chamber. DO NOT attempt to open
the air chamber supported within
the tool housing.
The driver assembly contains no
user-serviceable parts. Major com-
ponents such as the piston/driver
assembly, gearbox, piston stop and
guide body are all part of the drive
assembly.
Deliberate tampering with the drive
assembly may result in the release
of the driver.
Any repair or upgrade requiring
access to the pressure chamber
should be handled by an authorized
Senco dealer or service center.
To Next Page
Loading...
