EasyManua.ls Logo

Senco FN65DA - Battery Charge Time and Maintenance

Senco FN65DA
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

After normal usage, 45 minutes
of charge time is required to be
fully charged. A maximum charge
time of 1 hour or less is required to
recharge a completely discharged
battery pack.
Maintenance charge is indicated
when the red light turns off while
the green light ashes.
The battery pack will become
slightly warm to the touch whi le
charging. This is normal and does
not indicate a problem.
1 2 3 4 5
Battery is constructed with 4 LED
lights built into a panel on the
battery pack. These 4 LEDs reveal
the state of charge and indicate
possible problems inside the bat-
tery pack.
Red
Yellow
Green 1
Green 2
Push-button

Press raised green button on bat-
tery pack
to check charge.
Flashing = 0-15% charge
On = 16-25% charge
On = 26-50% charge
On = 51-75% charge
All On = 76-100% charge


Charge the battery pack before it
is completely discharged. Always
stop tool operation and charge the
battery when you notice less tool
power.
Never recharge a fully charged
battery cartridge. Overcharging
shortens the battery service life.
Charge the Lithium-ion battery
cartridge after 4-6 months from
previous charge.
21

Related product manuals