7.8 ERROR MESSAGES
"Buffer nearly full" will scroll across the large display when the internal buffer
is 90% full.
The message is cleared automatically when the level drops below 90%.
Alternatively the CLEAR key can be pressed.
FULL will flash on the large display when the internal buffer is full.
The message will clear automatically when space is available in the buffer,
ie., after a message is sent. If CLEAR is pressed the oldest data, not sent, in
the buffer will be overwritten next time a reading is saved.
NOTE: RS485 communications facilities are not available. They will be
implemented at a later date.
To Next Page
Loading...
