Sencon SI9500 - User Manual

SI9500
Digital Film Weight Gauge
User Manual
REF OPERATION
MANUAL No. 092-00600-08
LANGUAGE ENGLISH
REVISION 8

Summary

B. QUICK GUIDE

1. TO CALIBRATE FLAT SHEET PROBE;FORMED CAN PROBE.

Steps to calibrate flat sheet or formed can probes.

2. TO SET-UP A LACQUER TYPE.

Steps to set up a new lacquer type for measurement.

3. TO CALIBRATE A LACQUER TYPE.

Steps to calibrate a lacquer type after setup.

2. FAMILIARISATION AND PREPARING FOR USE

2.7 MASTER RESET

How to perform a master reset to restore factory settings.

2.13 CALIBRATING THE PROBE

3. USING THE INSTRUMENT IN FIXED CHANNEL MODE

3.5 READING FAULTS

How to identify and troubleshoot common faults.

4. USING THE INSTRUMENT IN CUSTOM CHANNEL MODE

4.2 SETTING UP A LACQUER TYPE

Detailed procedure for setting up a new lacquer type.

4.5 CALIBRATING A LACQUER TYPE

How to calibrate the instrument for a specific lacquer type.

4.8 READING FAULTS

Troubleshooting common faults in Custom Channel Mode.

4.10.1 MULTI-POINT CALIBRATION

6.6 SELECTING THE PRINTOUT FORMAT

6.7 PRINTER PROBLEMS

7.7 FORMAT OF MESSAGE TRANSMITTED

7.8 ERROR MESSAGES

A1.8 SWITCH DESIGNATION

Enable Printout and define Baud Rate

SWITCH BANK 2

Computer Transmission Baud Rate

9.APPENDIX 2

A2.1 ERROR MESSAGES

List and explanation of all error messages displayed by the SI9500.

Sencon SI9500 Specifications

General

Brand	Sencon
Model	SI9500
Category	Measuring Instruments
Language	English