SMP100 User Guide
12
Go to Module Configuration > ASI [Embedded]. Set the Constant rate of this port. Click Apply.
EMM and Other PIDs (EIT, SDT, TDT and other PIDs) can be output by drag-and-drop
procedures.
Embedded TSIP Output
The steps to configure IP output are similar to the ways to configure ASI output:
1. Go to Module Configuration > TSIP [Embedded]. Open output channels and set output
parameters.
2. Distribute services in Service Configuration page.
3. Verify the output bitrate in Status.
4. Set the Constant Rate in Module Configuration for the output channels.
If the Constant Rate is lower than the Effective Bitrate at a time, it will cause packet loss
issue. In that case, the Effective Bitrate of the corresponding output TS will be highlighted in red.
See the following image.
To Next Page
Loading...
General