Sencore SMP100 - Configuring Output

SMP100 User Guide
11
3.2.4 Configuring Output
Embedded ASI Output
Use the following two ways to create output TS:
1. Drag TS to TS
Click an input TS; drag and drop it on an empty output TS. Click Apply. See the following Image.
2. Drag Programs to Programs
Right-click an output TS. Click Add TS to assign Original Network ID and TS ID for this new TS.
Click OK, then an empty TS is created.
Click a service in the input port, drag and drop it on Program (0 Services) in the output area.
Click Apply before next step.
Go to Status > ASI [Embedded]. Verify the output Effective Bitrate of this ASI port.