SMP100 User Guide
13
3.2.5 Delete an Output TS/Program/PID
Move the cursor to a TS, Program or PID until a red icon ( ) appears. Click the red icon to delete
the service or PID. Click Apply before next step.
3.2.6 Version Information/Upgrade
Version Information/Upgrade page presents the software information. Check Advanced to view
all the software that are loaded in this unit.
Updating software
Click Browse to select the software. Then click Upgrade to start update process.
If it is a mainboard upgrade, SMP100 will reboot itself after upgrade is finished. If it is module
upgrade, Go to Module Configuration and click Reboot to load the module again.
To Next Page
Loading...