Sencore SMP100 - Upgrading STB through SMP

SMP100 User Guide
24
3.2.2 Upgrading STB through SMP
To update the software for a number of STB’s, use the following steps:
1. Feed the update stream to SMP by the embedded ASI or IP port.
2. Drag the update PID to QAM output port. See the following image, an update stream is taken as
other PID 8001 in SMP.
3. Add update descriptor in the NIT. Go to SI Edit page of the center TS. Add Network Descriptor
by right click on network_descriptors. Generally, the descriptor is from STB manufacturer.
4. Click OK to confirm. See the following image, the update descriptor is crated under NIT Actual.
5. Go to Service Configuration. Click Apply and Save.