SMP100 User Guide
52
2. Go to Service Configuration. Bypass the input TS and drag it to output Board3 [CI] on the
right side. Then on the left side in Board3 [CI] Port1 the processed TS is listed as an input
again.
3. Right-click a program in the output CI port to descramble this service by the CAM in Port 1.
[Descramble] follows the service that is descrambled as a mark. To cancel the descrambling
process for the service, right-click it and click Non-descramble. Click Apply.
4. Drag the service that has been descrambled from input Board3 [CI], Port1 to output port.
To Next Page
Loading...