Using the AMBEO Soundbar
AMBEO Soundbar | 37
▷ From the list of found Bluetooth devices, select “AMBEO Sound-
bar”. If necessary, enter the default pin code “0000”.
If pairing was successful, the st
atus LED lights up blue.
If no connection is established within 3 minutes, pairing mode
is terminated. If necessary, start the pairing mode again.
ON
2s
Hold
< 20 cm
Pairing
Connected
Stan‘s iPhone
The device name of the Soundbar can be changed in the Chromecast
app (e.g. “Soundbar family room”).
Disconnecting the AMBEO Soundbar from a Bluetooth device
▷ Via the menu of your Bluetooth device, disconnect the connection
to the Soundbar.
The Soundbar is disconnected from the Bluet
ooth device. The
display shows “Disconnected”. The status LED goes off.
Pairing the AMBEO Soundbar with an NFC device (NFC pairing)
▷ Activate Bluetooth and NFC on your Bluetooth device.
▷ Place your NFC device close (less than 3 cm) to the NFC antenna
on the Soundbar.
The status LED pulses blue. The devices are being paired.
If pairing was successful, the status LED lights up blue.
To Next Page
Loading...
