Putting the receiver into operation
15
왘 Connect the antennas. You have the following options:
– You can connect the supplied rod antennas to the rear of the
receiver (see page 13). In this case, insert the two blanking plugs
into the holes of the blanking plate (see diagram above).
– You can use the AM 2 antenna front mount kit (see “Accessories
and spare parts” on page 53) and mount the rod antennas to the
blanking plate (see diagram below).
When using more than one receiver, we recommend connecting
remote antennas and, if necessary, using Sennheiser antenna
accessories. Fore more information, visit the ew G3 product page at
www.sennheiser.com.
To Next Page
Loading...
