ENGLISH
Pag. 17
Error Possible cause Remedies
Calibration error
(ErrC)
Sensor’s reading out of range The zero calibration is not per-
formed
Zero calibration warning
(Ung0 – warning invalid zero)
The sensor has a non-zero re-
ading
The zero calibration is perfor-
med but with a warning notice
Span calibration warning
(Ung0 – warning invalid sensitivity)
The user has set a span value
out of range
The span calibration is perfor-
med but with a warning notice
Threshold setting error (ErrT) The user has set a threshold
out of range
The threshold is not memori-
sed
Hysteresis setting error (ErrT) The user has set a hysteresis
value out of range
The hysteresis is not memori-
sed
Address error (ErrA) The user has set a value out of
range (range: 1- 247)
The address is not memorised
Baudrate error (ErrB) The user has set a non-admis-
sible value (admissible values:
9600, 19200, 38400, 115200)
The baudrate value is not me-
morised
3.3 Operating errors
*
Start
NEXT
NEXT
NEXT
the modifyng value is blinkg* Set Value:
ENT ENT ENT
ENTENTENT
ENT ENT ENT
ENT ENT ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
by NEXT the value increases by 1,
by ENT the modifiable digit switches to the next one
Table 4) Posible kind of errors that can occur during operations with the SMART3G display
To Next Page
Loading...
