Need help?Do you have a question about the SensorTherm METIS H3 series and is the answer not in the manual?
General| Response Time | 150 ms |
|---|---|
| Power Supply | 12-30 VDC |
| Housing | Stainless steel |
| Protection Class | IP65 |
| Resolution | 0.1°C |
| Emissivity Setting | 0.100 to 1.000 adjustable |
| Analog Output | 0/4 to 20 mA |
| Digital Interface | RS485 |
| Accuracy | ±(0.3 % of reading + 2 °C) |
| Repeatability | ±(0.1 % of reading + 1 °C) |
Safety guidelines for electrical connections, mains voltage, and qualified personnel.
Crucial safety warnings and precautions for using the laser targeting light.
Details cable colors, pin functions, and connector pinouts for electrical connections.
Information on connecting the 24 V DC power supply and interpreting the operating status LED.
How to configure Analog Output 1 and 2 for measured temperature or control signals.
Setup options for digital inputs/outputs for functions like laser targeting or external triggers.
Technical details for serial communication, including cable length limitations and baud rates.
Information on connecting the pyrometer via Profibus-DP or Profinet interfaces.
Specific pin assignments for the Profibus-DP interface.
Specific pin assignments for the Profinet interface.
How to properly align the pyrometer to the target for accurate temperature measurement.
Using the laser targeting light for precise alignment with the spot size.
Using the through-lens sighting system for alignment and target observation.
How to align using the camera module's video output and TV screen.
How to adjust focus manually for optics.
Adjusting focus distance using device buttons or PC software.
Describes the functions of the PAR, Arrow, and ENTER buttons, including key lock.
A table listing adjustable parameters and their settings like T90, Emissivity, Interface type.
How to adjust response time for accurate temperature tracking.
How to set emissivity based on measuring object material for accurate readings.
Table of emissivity values for various materials and surface textures.
How to start SensorTools and connect to the pyrometer via COM or USB ports.
Navigating the SensorTools interface, viewing measurements, and accessing device settings.
Main interface for configuring pyrometer settings like temperature sub range, analog outputs, and language.
Detailed explanation of the control window elements, including measured temperature, setpoint, and device parameters.
Main interface for configuring pyrometer settings like temperature sub range, analog outputs, and language.
Setting up digital inputs/outputs for functions like parameter selection or external triggers.
Managing data collection, including data format, buffer mode, and transmission rates.
Step-by-step guide for readjusting the pyrometer to a specific measuring temperature.
Introduction to the integrated PID controller and its basic setup.
Detailed explanation of PID parameters like Proportional Band, Integral Time, and Derivative Time.
Choosing fieldbus modes (Metis, Fixed Format M3, Custom Format M3) for data transfer.
Storing and activating up to 7 different parameter settings (setups) via digital inputs.
Step-by-step guide for updating pyrometer firmware using SensorFlash software.
Table detailing specifications for M308, M309, M313, M316, M318, M323 models.
Table detailing specifications for H309, H316, H318 models.
Procedure for replacing the protection window or lens on manual focus optics.
Detailed list of commands (aa, ar, as, bn, bum, etc.) and their parameters.
Continues the list of interface commands (ia, if, io, in, la, lg, etc.) and their functions.
Further interface commands related to PID controllers and camera modules (hz, ob, rg, ro, rz, sg1, etc.).
Final commands related to camera settings, motorized focus, and Profibus (ot, ov, vb, vc, vd, vh, vi, vm, vq, vt, moa, fpa, fbm, fbr, fbd, fbx).
To Next Page
