102
103
Erasing all programs
To erase all programs stored in program areas 0 through 9,
specify the PCL mode and press and then .
Erase the programs stored in P0 , P4 , P8 , and P9.
Cautions concerning the calculation modes
All key operations available in each calculation mode can
be stored as programs, but, depending on the calculation
mode, certain commands of functions cannot be used.
BASE-N mode
• Function calculations cannot be performed.
• Units of angular measurement cannot be specified.
• All program commands can be used.
• Be sure to include a " " at the final result output to return
to the previous calculation mode when a program
execution is terminated. Failure to do so may result in a
decimal display or an error.
SD mode
• Among the functions, Abs and
3
√ cannot be used.
• Among the program commands, Dsz, > and < cannot be
used.
LR mode
• Among the functions, Abs and
3
√ cannot be used.
• Among the program commands, , =, ≠, lsz, ≥, ≤, Dsz,
> and < cannot be used.
Erasing of programs is performed in the PCL mode. Press
to specify the PCL mode . There are two
methods used to erase programs: erasing a program
located in a single program area, and erasing all programs.
Erasing a single program
To erase a program in a single program area, specify the
PCL mode and press the key after specifying the
program area.
Erase the program in P3 only.
To Next Page
Loading...
Need help?
General
