73
Notes:
1. Always clean the winch and the accessories after use.
2. Check the emergency stop function.
3. Pull out the rope and inspect for deformation, damage and wear in accordance
with 6.5 Wire rope. Lubricate.
Note:
If the wire rope is replaced for a winch equipped with spooling device the
automatic rope spooling device is to be calibrated or controlled in
accordance with 3.7 Calibration of automatic rope spooling device.
4. Inspect the rope drum and rope wedge for correct installation and function.
5. Inspect and adjust in accordance with 6.2 Drum brake. Replace the brake
lining when the thickness is less than 1 mm.
6. Inspect the pressure roller for deformation, damage and wear.
7. Inspect the rope guides for deformation, damage and wear. Lubricate.
8. Check that the drum seal ring is in place and in good condition.
9. Check that the free-spool clutch has an unrestricted full movement in
accordance with 6.4 Free-spool clutch. Lubricate moving components.
10. Drain the winch gear from moisture.
11. Inspect the rope sheave and shaft for deformation, damage and wear.
Maintenance
Do not lubricate the shaft, keep it dry and clean.
Caution
12. Check the sensor function.
13. Inspect the helix screw for deformation, damage and wear.
14. Inspect the rope guide. Lubricate.
15. Inspect the gear drive. Lubricate.
16. Inspect the frame assembly for deformation, damage and wear. Lubricate.
17. Inspect the rope sheave and shaft for deformation, damage and wear.
Do not lubricate the shaft, keep it dry and clean.
Caution
To Next Page
Loading...
