74
18. Inspect the gear drive and grease winches with grease nipple.
19. Check the gear oil level. Drain and rell the gear oil.
20. Check all xation bolts. If necessary tighten up.
Note:
Ensure that tightening torques are in accordance with the table below or with
the manufacturer’s specications.
21. Inspect the hydraulic tubes, pipes and ttings for leakage, deformation,
damage and wear.
22. Inspect the electrical cables and connectors for damage and wear.
23. Inspect the equipment for corrosion and paint removal, repaint if necessary.
Maintenance
To Next Page
Loading...
