1.3
Handling
For a safe handling Serstech AB recommends Users to do as following:
§
Store the product in a dry and ventilated environment.
§
Do not attempt to repair the product by yourself, contact SERSTECH or your SER-
STECH reseller for service matters.
§
This product shall be used in compliance with local laws and regulations.
§
Always follow your organization’s procedure and regulations for the handling of un-
known substances.
§
Always use small sample sizes to limit possible hazards.
§
Dark substances can sometimes absorb the energy from the laser and could possibly
ignite, or if it is an explosive, be detonated by the laser. If you are in doubt - We
recommend starting with low laser power and work your way up in strength if neces-
sary and use the “delay start” function - to have time to safely move away from the
sample before the measurement is initiated.
§
Make sure to always keep the instrument in environments that is line with the storage
temperature of the instruments (-30 to +50°C). Storing device outside this range may
cause thermal damage to batteries.
§
Make sure to only run the instrument within the stated temperature range of operation
(-20 to +50°C). Note that tat the battery performance will be significantly lower to-
wards the end points of this range. In the upper temperature range issues with thermal
noise may hamper the performance and reduce the ability to identify weak Raman
scatterers.
The warranty is void if the product has been damaged by accident, unreasonable use,
neglect or if the unit has been opened or tampered with or other causes not arising from
defects in material or workmanship. This product is not designed to be intrinsically safe and
the user should take the necessary precautions when using the unit.
The product is designed to be used in an everyday field environment and is therefore
considerably more rugged than a laboratory unit. But it is important for the user to recognize
that it is a precision instrument and should be treated with care. Abuse and mistreatment
may lead to a degradation of performance or premature failure.
1.4
Intellectual Property Rights
SERSTECH AB has intellectual property rights relating to technology embodied in the
product described in this document. In particular, and without limitation, these intellectual
property rights may include patents or pending patent applications in the US and other coun-
tries. This product contains third-party software.
1.5
Equipment Modifications
This equipment must be installed and used in strict accordance with the instructions
given in the user documentation. This equipment contains no user-serviceable components.
Unauthorized equipment changes or modifications will invalidate all applicable regulatory
certifications and approvals
1.6
Trademark Acknowledgments
is a trademark of SERSTECH AB. All other company names and prod-
ucts are trademarks or registered trademarks of their respective companies. Ethernet,
To Next Page
Loading...