Disclaimer: We would like to inform you that we have made a replacement on the sample
preparation bottle. Some pictures might still show the old one.
Now, from the sample prepara-
tion bottle containing the solu-
tion, break off the seal on top of
the sample preparation bot-
tle and place at least one
drop in the center of
the washer.
Disclaimer: We would like to inform you that we
have made a replacement on the sample prep-
aration bottle. Some pictures might
still show the old one.
Note: Be careful to place the
drop in the center of the
washer, where the SERS sur-
face is. Ensure the drop is into
the center of the SERS surface.
If the SERS surface is not wet,
the solution will not be analyzed
by Arx.
Disclaimer: We would like to inform you that we
have made a replacement on the sample prep-
aration bottle. Some pictures might
still show the old one.
To Next Page
Loading...