30
Connection and Operation
The LA10 can be operated in three
different ways, with or without mul-
tichannel or a mixed mode. Each of the
modes is recognized automatically by
the assigned input signals.
… without multichannel
If there is no multichannel function on
the radio available the lighting system
can be controlled by two normal receiver
channels. A third channel is only neces-
sary if the extra outputs should be
switched individually and not by US-rear
light, additional fog or parking light or to
control trailer functions on AMO/AM10*.
On the radio switches or buttons with
three positions are required or joystick
channels.
Handling of LA10 is comparable with
UL4, ML4, M20+, M24.
Two or three servo cables need to be
connected to the receiver.
Input F1: Indicator, hazard light, park-
ing light and low beam
L/R - Short operation of the joystick or
switch to the left or right from the middle
position enables or disables the indica-
tors. Switching on an indicator, the cor-
responding cornering light is turned on
as well.
L - Long operation to the left switches
the hazard lights on/off.
R - Long operation to the right activates
the parking lights and after a second the
low beam. Operating again from the
middle to the right switches off the park-
ing lights and the low beam.
Input F2: Flasher, high beam and fog
lights
L/R - Short operation to the right acti-
vates the flash light. Short operation to
the left activates the Servo 4 on the
trailer.
R - Long operation of the joystick to the
right activates the high beam.
L - Long operation to the left activates
the fog front lights and after a second
the rear fog lights. Repeating the same
procedure from the middle position disa-
bles the fog front lights as well as the
rear fog lights.
To Next Page
Loading...
Need help?
General