42
Safety Notes
Do not expose the module to water or
oil. Do not cover it with foam. Discon-
nect the battery immediately after use.
Do not connect the battery with wrong
polarity. Avoid any short circuits. Always
use caution when connecting the bat-
tery. Always turn on the transmitter first.
Warranty Information
Warranty is granted for one year from
date of purchase. This warranty does
not cover damage due to incorrect han-
dling or wiring, over voltage or overload-
ing. This warranty does not cover
consequential, incidental or collateral
damage under any circumstances. By
the act of using this product the user
accepts all resulting liability.
Subject to change without notice.
www.servonaut.de
Helpful Tips
· in contrast to light bulbs, the LEDs
must be correctly connected. This
means, the cathode has to be con-
nected to the negative pole and the
anode to the positive pole. Never
connect an LED for testing purpos-
es to a battery. Use a suitable re-
sistor of e.g. 1kOhm instead.
· LEDs can be connected in series
without a problem. Only thing nec-
essary is a sufficient operating volt-
age (battery voltage). A series
resistance is always needed.
· First adjust the steering servo horn
and linkage carefully, then make
only fine adjustments with your RC
radio. Otherwise the cornering
lights might not switch on and off
properly.
Related Servonaut products
· E22 speed controller with cruise
control
· S22 speed controller without cruise
control
To Next Page
Loading...