SEW-Eurodrive ECDriveS - Startup of full PLC configuration

5
Startup
Startup of "full PLC configuration"
Manual – ECDriveS
®
22
5.2 Startup of "full PLC configuration"
In contrast to "standard configuration", the ECShell engineering software is not
needed in "full PLC configuration", because all the settings are performed by the
higher-level PLC.
To configure a node in "full PLC configuration" mode in the TIA Portal engineering
tool, proceed as follows:
1. Using drag and drop, drag the desired DAP [3] from the hardware catalog [2] to the
PROFINET IO system [1].
[1]
[2]
[3]
25149121675
[1] PROFINET IO system
[2] Hardware catalog
[3] DAP
In contrast to "standard configuration", you can freely select the PROFINET device
name and the IP address in accordance with the PROFINET guidelines.
25938274/EN – 01/2019