SEW-Eurodrive ECDriveS - Output data ZPA mode

6
Appendix
Description of the access points
Manual – ECDriveS
®
43
6.1.6 Output data "ZPA mode"
Process
data word
[PO]
Data
type
Designation Bytewise
notation
[byte.bit]
Wordwise
notation
[word.bit]
Description
0
Dword InductTrackingOnUpstream
0.0
0.7
0.0
0.15
Tracking code (32bit) for material being conveyed on
upstream zone
1.0
1.7
1 2.0
2.7
1.0
1.15
3.0
3.7
2
Dword InductTrackingOnDownstream
4.0
4.7
2.0
2.15
Tracking code (32bit) for material being conveyed on
upstream zone
5.0
5.7
3 6.0
6.7
3.0
3.15
7.0
7.7
4
Struct
Bool
AccumulateControlUpstream 8.0 4.0
AccumUpstreamToThisZone: Jam material being con-
veyed in the upstream zone. Can be used when feeding
in to hold the material being conveyed in the upstream
zone during the feed-in procedure
Bool 8.1 4.1
FakeConfirm: Interruptflag. Used to avoid a jam error if,
for example, material being conveyed is removed from a
removal buffer during ongoing operation
8.2
8.7
4.2
4.7
Res.
Bool 9.0 4.8 Accumulate: Jam material being conveyed in this zone
9.1
9.7
4.9
4.15
Res.
5
Struct
Bool
AccumulateControlDown-
stream
10.0 5.0
AccumUpstreamToThisZone: Jam material being con-
veyed in the upstream zone. Can be used when feeding
in to hold the material being conveyed in the upstream
zone during the feed-in procedure
Bool 10.1 5.1
FakeConfirm: Interruptflag. Used to avoid a jam error if,
for example, material being conveyed is removed from a
removal buffer during ongoing operation
10.2
10.7
5.2
5.7
Res.
Bool 11.0 5.8
Accumulate: Accumulate material being conveyed in
this zone
11.1
11.7
5.9
5.15
Res.
6
Int LeftMDRSpeed
12.0
12.7
6.0
6.15
Speed/rotational speed of the left drive
with ECR: v(ECR) [m/s]×1000
with ECG: v(ECG) [rpm]×10
13.0
13.7
7
Int LeftMDRSpeed
14.0
14.7
7.0
7.15
Speed/rotational speed of the right drive
with ECR: v(ECR) [m/s]×1000
with ECG: v(ECG) [rpm]×10
15.0
15.7
25938274/EN – 01/2019